Fittings

1) Hang your RAM’N Drill a hole in the wall and insert a rawlplug. Drill a hole in the wall and insert a rawplug. Hold the back panel and the two panels of the frame against the wall so that you can see the hole in the wall through the hole in the panels. Screw the screw through the hole and click on the outer frame. Now your RAM’N hangs nicely on the wall and can rotate 360 degrees. 2) Frame the drawings Hold the drawing up against the frame and give it a light press. Whoop! Now it is framed, exactly as a work of art deserves! There is room for as many as 50 works of art, so finally unleash your creativity. There is room for as many as 50 works of art, so finally unleash your creativity. 3) Empty RAM’N again
When your RAM’N is full, you can easily empty it again by pulling out the outer frame so that it clicks off. The many fine works of art can now be browsed in chronological order and the RAM’N can be refilled. 4) Replace the acrylic inner frame
Give your RAM’N a new look by replacing the acrylic inner frame. Grasp the acrylic edge on the long side of the frame and pull it towards the centre of the frame until it bends slightly and gives way. Now you can easily remove the remaining edges and insert new ones.